Rice field fermentation bed duck key technology

Rice field fermentation bed duck key technology

Xia Xin Zhang Baoquan

Compared with the traditional duck-drinking model, the Jinbao rice paddy fermentation bed duck technology has the functions of labor saving, grain saving, provincial medicine, and power saving, which saves a lot of costs, increases economic efficiency, and can be slaughtered in advance for about a week. It can increase the weight by several hundred grams. It is an advanced and scientific breeding mode. The padding can use the local rice husks, which can greatly save the cost of litter. However, the rice field fermentation bed ducks often directly affect the efficiency of the fermentation bed due to some key problems. The following briefly introduces several key issues in the duck bed fermentation bed for the reference of the farmers in the use of the fermentation bed.

A, moistureproof and waterproof

Because the foundation of the fermentation bed is built on the basis of paddy fields, the rice paddy soil is damp. To prevent the litter from sucking water from the mud, it is also possible to prevent the rainwater from accumulating in the rain bed from soaking the fermentation bed and causing the fermentation bed to be scrapped. Therefore, in the production of fermentation beds to raise the fermentation bed surface, the following measures can be used: 1) make the ground type, you can use soil or bricks, pebbles, etc. laying in the bottom of the fermentation bed, so that the bottom of the fermentation bed above the paddy field surface at least Above 20 cm, the higher the layer height is, the better, and avoid rain or water soaking in the fermentation bed, where the cost of using local soils is higher; 2) Deeply digging the drainage ditch, speeding up the installation of drainage equipment, Drainage ditches should be dug as deep as possible, and the ditch depth should not be less than one metre to prevent the rainwater from soaking the fermentation bed too much. This is in line with the theory of fear of dampness in the Jinbao fermentation bed.

Second, according to the growth of the duck group stage management

The growth stages of ducks are not the same, and the size and excretion of excrement are not the same. Therefore, the density should be reasonably arranged. For example, for 25 days before, the goldfish fermentation bed culture can withstand the breeding density of 7-8 per square meter, but after 25 days With the gradual increase of excretion, the fermentation bed can not decompose the excess manure beyond the load of the fermentation bed. Therefore, the breeding density should be reduced. The “Golden Circle” or “ABC circle” system is recommended for the Jinbao fermentation bed, ie 25 Day before the use of a small area of ​​A circle, 25 days after the opening of B, C large pen home, such as the original 1 duck group is divided into 2, or 2 duck groups are divided into 3, or the original small area housing Replace the large-area housing with twice the area, and set a dedicated channel in the middle or at both ends to reduce the culture density and reduce the excretion, so that the fermentation bed can play a long-term, stable and sustained function.

Third, litter maintenance

The maintenance of litter also directly affects the decomposition rate of the ecological fermentation bed, and also affects the operation of the fermentation bed in the long term. Therefore, the frequency of turning over the litter is increased in the daily feeding work (eg, over 2-3 times per week). The tipping depth of the fermentation bed is 30-40 cm. If only 20 cm is turned over for a long period of time, it is very difficult for the manure to be fermented. And according to the need to add a certain amount of litter and strains, can not reduce the amount of cost savings, otherwise it will have the opposite effect, such as Jinbao suggested that 1 kg of starter to do 12-15 square, the amount is too small, the decomposition efficiency will be greatly discount.

IV. Disinfection of Fermentation Beds

To correct the problem that the fermentation bed cannot be disinfected, for the empty-barreled fermentation bed, the disinfectant can be normally sprayed without affecting the subsequent use of the fermentation bed.

Hyaluronic Acid Eye Drops Sodium Hyaluronate (HA), Pure Hyaluronic Acid could be used in eye surgery, such as Hyaluronic Acid Eye Drops, corneal transplantation, cataract surgery, glaucoma surgery, and surgery to repair retinal detachment.

 

Eye Drop Grade Hyaluronic Acid Powder is an important component of intercellular substance, eye vitreous body, joint fluid and other connective tissue. It acts the important physiologic roles in holding body's moisture, maintaining extracellular space, adjusting osmotic pressure, lubricating and promoting cells to repair in the body. Sodium Hyaluronate can be used as viscoelastic agent inintraocular lens implantation operation, as the filler in the osteoarthritis and rheumatoid arthritis and otherjoint surgery, as a medium widely used in eye drops, it also can be used to prevent postoperative adhesion and facilitate the wound heal. The compounds formed by the reaction of Sodium Hyaluronate with other drugs play a drug release effect role, thus achieve the purpose of drug targeted and time controlled release.

 

With the development of medical technology, Sodium Hyaluronate has been more and more widely used in medical applications. In 1976, Sodium Hyaluronate was first commercialized and used as ophthalmic viscoelastic agents, which is a significant progress in the ophthalmic industry. In 1987, Sodium Hyaluronate for intra-articular injection came in to the market. In 1990s, the large-scale production of Sodium Hyaluronate by fermentation made the cost lower, thus products containing Sodium Hyaluronate such as eye-drops, dermal fillers and other Sodium Hyaluronate preparations started to be used extensively.

 Eye Drops Grade Sodium Hyaluronate

Specification

Test Items

Standard

Appearance

White powder

Hyaluronic  acid

≥95%

Molecular weight

≥2.0 X 106 Da

PH

6.0-7.5 

Loss on drying

≤10%

Protein

≤0.08%

Nitrogen

3.0%-4.0%

Heavy metal

≤10ppm

Bacterial counts

≤80cfu/g

Mold and Yeast

≤10cfu/g

Sterile Test

Complies

Shelf Life

Two Years

Conclusion

The results meet the standard

 

Eye Drop Grade Hyaluronic Acid Powder

Pure Hyaluronic Acid Powder,Hyaluronic Acid Eye Drops,Hyaluronic Eye Drops,Eye Drop Grade Hyaluronic Acid Powder

Qufu Hi-Tech Trading Co., Ltd. , https://www.chinahyaluronic-acid.com

Posted on