Water bath thermostat oscillator operating instructions

1. Please read this manual carefully before use.

2. The working plane of the water bath thermostat oscillator should not be excessively smooth (eg tiles, etc.).

3. The electrical rating of the socket provided by the user should not be less than the electrical rating of the machine and have good grounding measures.

4. The whole machine is strictly prohibited from being used in direct sunlight.

5. The speed regulation should start slowly from low speed to high speed.

6, the water bath thermostat oscillator may have a certain shift in high-speed oscillation, so it should be taken care of when using.

1. Load the test bottle and keep it balanced. If it is a dual-function model, set the oscillation mode.

2. Turn on the power and set the timing according to the surface scale of the machine. If you need to work for a long time, adjust the timer to the “normally open” position.

3. Turn on the power switch and set the constant temperature:

(1) The water bath thermostat oscillator will set the control small switch to the “set” section. At this time, the temperature displayed on the display screen is the set temperature, and the adjustment knob can be set to the temperature required for your work. (The operating temperature you set should be higher than the ambient temperature. At this point, the machine starts to heat up, the yellow indicator light is on, otherwise the machine does not work)

(2) The water bath thermostat oscillator places the small switch of the control part on the “measurement” end. At this time, the temperature displayed on the display screen is the actual temperature of the air in the test chamber. As the temperature inside the box changes, the displayed number will change accordingly. .

(3) When heated to the temperature you need, the heating will stop automatically and the green indicator light will be on; when the heat in the test chamber is dissipated below the temperature you set, a new round of heating will start again.