First, there is no use of lubricants according to the season. Different grades of lubricant should be used in different seasons. Some diesel-burning tiles are caused by the use of small-viscosity lubricants in the summer and the formation of oil film on the bearing surfaces.
The second is that the lubricating oil is not clean. If dirty oil is added to the body, it will block the oil path and cause burns.
The third is to add the oil amount. If there is too much oil, the engine will burn oil easily when the engine is running, and carbon deposit will be formed. If too little, the shaft will be burned due to poor lubrication. The most common oil surface is between the upper and lower scales of the dipstick.
Fourth, do not pay attention to observe the instrument. When the diesel engine works normally, the oil pressure should be between (0.15~0.25)MPa, and the idle oil pressure should not be less than 0.5MPa. Many operators rarely pay attention to oil pressure gauges, and therefore cannot detect hidden troubles in time.
Fifth, the clearance between the shaft and the tile does not meet the standard. If the clearance is too small, the oil will not enter easily and the oil film will not form. The clearance is too large, the oil is easily lost, and the oil film layer is difficult to form. Therefore, when repairing the assembly, it must be ensured that the bearing clearance is within the standard range.
Sixth, it is a long-term overload that causes burning of tiles. Due to long-term overload operation, the engine temperature is high, and the engine speed is low, the bearing capacity of the bearing bushes increases, the oil pump oil supply is reduced accordingly, and the viscosity of the oil decreases at high temperatures, which is more likely to cause burning of tiles.
Grips can be made of materials like stainless steel, plastic, aluminium, silicon, etc. Tattoo Grips are used in together with
tube stems to form the grip that you hold a Tattoo Machine with. Stainless Steel Tattoo Grips require an autoclave to
properly sterilize. A barrier method to keep the tattoo grip clean like a tattoo machine bag can be used, however, it
is still necessary to properly sterilize all grips & tubes and needles via an autoclave if the intention is to reuse these products.
Magnum Tattoo Grips,Magnum Tattoo Tubes,Disposable Magnum Tattoo Grip,Stainless Steel Magnum Tattoo Grips
Redtop Tattoo Supply Co., Limited , http://www.redtop-tattoo.com